Wall Plugin for SketchUp

[Medeek]

[Medeek]

Is 8,000 sqft too large? I'm going to say yes, at least for most people.



Besides the regular mdkBIM plugins I also used the grid tool (Medeek Project), but the regular SketchUp grid tool works just as well. A grid tool is a requirement in my opinion, you really need something like this for laying things out correctly.

I also used TIG's mirror tool for certain manual modeling tasks.

The trim and extend tools in the Medeek Project were also very handy for creating my diagonal braces.

[Medeek]

Version 3.7.2 - 10.13.2024
- Fixed a critical bug with the in-wall column module.
- Added the following additional Wide Flange (W14) beams to the beam module: W14X38, W14X43, W14X48, W14X53, W14X61, W14X68, W14X74, W14X82, W14X90, W14X99
- Added the following additional Wide Flange (W16) beams to the beam module: W16X45, W16X50, W16X57, W16X67, W16X77, W16X89, W16X100
- Enabled a wood grain and an end grain material for glulam beams within the beam module.
- Enable additional built-in materials for "Custom" in-wall columns.
- Added the following (27 - low poly) Simpson column bases to the post module: CB7_6, CB1212, CB1012, CB1010, CB812, CB810, CB718_7, CB718_6, CB718_4, CB612, CB610, CB88, CB86, CB68, CB64, CB48, CB46, CB9_105, CB9_75, CB9_9, CB9_6, CB7_105, CB7_75, CB7_9, CB6_7, CB5_45, CB5_6
- Added the following (6 - low poly) Simpson column caps to the post module: CCQ84, CCQ86, CCQ94, CCQ96, CCQ98, CCQ106

[Medeek]

Version 3.7.4 - 10.22.2024
- Added the following (27 - low poly) Simpson post caps to the post module: 1616HTQ_8, 1616HTQ_6, BC8, BC6, BC4, BC46, RTC44, LCE4_64, LCE4_46, LCE4_6, LCE_4, AC4R_4R, ACH6_8, ACH6_4, ACH6_6, ACH6E_8, ACH6E_4, ACH6E_6, ACH4E_6, ACH4E_4, ACH4_6, ACH4_4, AC6_4, AC4_6, AC4_4, AC6_6, AC6R_6R