I know I am supposed to leave an 1\8 (or 16th dending on the direction? Wagner 111) inch gap between my sheathing. I asked some people how to do that and got several replies.
Someone said the OSB sold for sheathing is an 1/8th inch short. I believed this one until I put a tape on it just now.
Someone else said to put it up tight and then run a circular saw down the seam set at 7/16ths deep. This sounded like way more work than a normal framing crew would do. (I stopped by a new neighborhood to see if I could tell what they were doing, but I don't think I'll follow their example. Their gaps were more like an half an inch to an inch -yes that means that some of the OSB ran off the stud. But I'm sure it will be OK because it's not plumb - so some of every sheet seemed nailed in :o )
Someone else said - you're not building a piano - don't worry.
What should I do? Won't I start to run off the stud if I am doing 8' + 1/16th for each sheet?
Thanks.
I know what it says - don't think I've been on a job where anyone worried about it. PEG might. :)
On the playhouse floor sheathing, there was a natural 1/8" gap between the T&G once it all got tapped into place.
[highlight]I just touch the sheets together [/highlight], don't slamum uo "extra tight" make sure the ends are back a little 1/8 / 1/4 instead of hanging over a 1/16.
If your going to be months before your in the dry , gapping might be a good idea , but if it's OSB and it swells no matter how much you gap it it well not be enought.
I used those metal spacers designed for sheathing...I'm not worried about code here, not in city limits, but aren't those basically what folks use ?? They are about an inch and a half wide and just slip onto both edges, leaving the desired gap...boom, done.....jb
i wa s on a job recently antd the osb was 1/8" narrow. we used a nail on the top and bottom as a spacer that was about 1/8 inch thick.
in fact wee had to take down 12 shees and put them back up thankfully they were not anild but with a few nails with the plan to go back and nail over
i have seen rooofs buckle badly so i always space them out as they say
Ok Stop are we talking wall sheathing or roof sheathing.
On walls butt it GENTLY together no added force .
On roof with 24" OC truss's or rafter use 1 ea. "H" clip between each rafter, one per rafter bay, the end of the sheets again just touch together no added force , or gap them a little .
Some OSB, I hear , is "down sized " but I never seen any . And I'll bet I've laid more sheets of CDX / OSB than anyone on this forum.
Again YMMV .
If your going to be a long time IE more than month without a roof gapping may help some what , BUT when/ once OSB swells it , never shrinks back any , it just gets thicker , and thicker .
Good luck PEG
QuoteOk Stop are we talking wall sheathing or roof sheathing.
On walls butt it GENTLY together no added force .
On roof with 24" OC truss's or rafter use 1 ea. "H" clip between each rafter, one per rafter bay, the end of the sheets again just touch together no added force , or gap them a little .
Talking about walls (for now). I'll butt gently.
I'll use the clip, with plywood, and dry it in quickly :)