1x4 T&G pine

Started by astidham, September 05, 2011, 10:21:34 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

astidham

September 05, 2011, 10:21:34 PM
what is the most common way to attach T&G pine to the stud wall? trim nailer, Stapler?
I need suggestions.
"Chop your own wood and it will warm you twice"
— Henry Ford

MountainDon

#1
September 05, 2011, 10:23:26 PM
nails
Just because something has been done and has not failed, doesn't mean it is good design.

MountainDon

#2
September 05, 2011, 10:24:35 PM
 :)

I use a Senco finish nailer and nail through the tongue at an angle.
Just because something has been done and has not failed, doesn't mean it is good design.

astidham

#3
September 05, 2011, 10:25:27 PM
"Chop your own wood and it will warm you twice"
— Henry Ford

astidham

#4
September 05, 2011, 10:30:21 PM
whats a good length of nail for this in your opinion?
"Chop your own wood and it will warm you twice"
— Henry Ford

MountainDon

#5
September 05, 2011, 11:30:25 PM
 ???

I used 15 gauge 2". Partly because that is the longest nail my baby Senco gun loads and partly because I had two boxes of them.  I believe 2 inch is the minimum for 5/8 to 3/4 material, but longer can not hurt.

Just because something has been done and has not failed, doesn't mean it is good design.
Print
Go Up Pages1
User actions