I needed a project to keep busy over Thanksgiving. I had about a dozen scrap 2x4s about 3 ft long and a ½ sheet of ¼" plywood. I ripped the 2x4s with the table saw and ran them through the planer. Glued up a few for the top bottom and doors. Legs are 2/4s cut in half and run through the planer. Ran a few through the table saw for the dados for the sides and back. Stained with chesnut and 3 coats of satin poly . . . I did have to spend some money on hardware. Handles, hinges and drawer slides.
/.
(https://i38.photobucket.com/albums/e149/bayviewps/DSCN0422.jpg)
I like it! [cool]
Some nice looking scrap you've got there, bayview! Did you use plans or anything?
[cool]
Quote from: Ernest T. Bass on December 04, 2010, 08:25:27 PM
Some nice looking scrap you've got there, bayview! Did you use plans or anything?
Thanks for the positive comments . . . I didn't have any plans but, I wanted a simple - country look . . . I didn't notice until I looked at the picture . . . Next time I will try to match the grain on the doors a little better.
Maybe some nightstands and a headboard next.
Cleaning up the garage - workshop this weekend. Adding some more interior florescent lights and some outside motion-detection lights. . .
/.
Very Nice.
Sweeeeet!